
Art Clay Gold 22k - Clay Type
Instructions:
Thank you for purchasing ART CLAY GOLD/K22. As this has different characteristic from original ART CLAY SILVER clay type, please read the directions and precautions before use.
INGREDIENTS: 95% of indicated weight is K22 (Gold 91.7%, Silver 8.3 %). After firing: K22 100%
FIRING TEMPERATURE / HOLDING TIME: 1814ºF for 60 min.
MELTING POINT: 1931ºF
[Directions]
|
Preparation
|
- Take out only the necessary amount of clay, wrap it in plastic wrap and knead it well. If it is stiff at first, warm it in your palm a little while. Place the unused portion of clay in a zip loc bag and keep it in an air-tight container at room temperature to prevent it from drying up.
|
|
Molding
|
- To join Art Clay Gold together or to mend a jointed area, use Art Clay Gold in paste form, which can be made as follows: Put Art Clay Gold in a small plate Add a few drops of water and blend it evenly with something like a spatula.
- Shape as you wish using your fingers, a mold, etc. If Art Clay Gold becomes stiff to handle, place it in a zip loc bag, add a few drops of water, and knead it until it becomes soft.
Note: Remember that the finished piece shrinks 15%, so size your piece accordingly.
|
|
Drying
|
Condition for Drying
Dry the piece completely at room temperature (more than 24 hours) or by a hair dryer, etc.
|
Hair
Dryer
|
Approximately 10-15 minutes with 1200w hair dryer. Place the dryer within 6 inches from the piece. |
|
Cooking
Plate
|
Approximately 10 min. at 300-350ºF. |
|
Electric Kiln
|
Approximately 10 minutes 300ºF |
Drying time is varies by size of the piece.
- How to Check If the Piece is Completely Dried
Place the piece on a flat stainless, glass or plastic plate. After 10~20 seconds remove the piece. If there is no area of condensation left behind, it is completely dried.
|
|
Firing
|
Place the piece in the kiln. (If you are firing more than two pieces, make sure the pieces are not touching each other)
|
Temperature
|
1814ºF |
|
Holding Time
|
60 min.
|
Take out the piece when the kiln temperature falls below 1112ºF. |
|
Finishing
|
- The surface of the fired piece will be matte, but luster can be obtained by polishing. ( e.g. stainless brush, burnisher, sandpaper, etc.)
|
|
Completing
|
- After firing: K22 - 100%.
|
[Precautions]
- Keep the clay Indoors out of direct sunlight.
- Use it as soon as possible after opening the package.
- Be careful of hot surfaces.
- Ventilate your workroom well during firing.
- Keep this product out of the reach of children.
- If you get any of this product in your eyes or mouth, flush immediately with plenty of water and call your physician.
|
|
|